Exodus Alarm Banner_New
Auckland Home Show
See Photos HERE
KBD Banner

Our new range of Exodus Wireless Solar Powered Infrared Multi Beam Sensors offer are a new generation of perimeter intrusion detectors and are developed with mature solar photo-voltaic cell technology and widely-applied FM & AM radio signal transmission technology.

Compared with traditional active wired and wireless infrared sensors the Solar Powered Wireless Infrared Sensors are extremely easy to install and maintain and are by far a superior product to all its earlier non solar powered rivals. Simple installation either on a post or a wall using the provided brackets.

The Multi Beams reduce false alarms and increase the level of security, the Solar Sensors also operate in all weather conditions including heavy fog and will remain charged for at least 30 days without any direct light access.

We have a range of sizes and types available to suit almost any requirement, these sensors can also connect via our “Switch out Adapter” to any wired Alarm System and also to our 8800, 8900 and T1 Alarm Panels. If you do not have an existing wired alarm system then you will also require the “2020C Solar Alarm Panel Receiver”.

Up to 100 Solar Sensors can be programmed into the 2020C Alarm Panel Receiver (as below) plus it also has a built in Phone Dialer (including CID Protocol for Alarm Center Monitoring) and will call you if the Sensors are triggered and phone numbers have been entered into the Panel. Easy Arming and Disarming using the provided Remote Controls.

Ideal for monitoring Driveways, Commercial properties, Fence or Boundary lines, Back yards, Gateways, Exterior Windows and Doors etc.

XS-SB001-S4  -  4 Beams

Please select Shipping Option HERE before checkout

$345

$295
Can position up to 10 metres apart and can be mounted up to 100 metres from the receiver Alarm Panel.
Dimensions - H620 x W42 x D40mm

XS-SB001-S8  -  8 Beams

Out of Stock

$445

$375
Can position up to 10 metres apart and can be mounted up to 100 metres from the receiver Alarm Panel.
Dimensions - H1120 x W42 x D40mm  

XS-SB001-R4  -  4 Beams

$469

$395
Can position up to 100 metres apart and can be mounted up to 1000 metres from the receiver Alarm Panel.
Dimensions - H590 x W84 x D45mm  

XS-SB001-R6  -  6 Beams

$565

$475
Can position up to 100 metres apart and can be mounted up to 1000 metres from the receiver Alarm Panel.
Dimensions - H840 x W84 x D45mm   

XS-SB001-R8  -  8 Beams

Out of Stock

$625

$545
Can position up to 100 metres apart and can be mounted up to 1000 metres from the receiver Alarm Panel.
Dimensions - H1090 x W84 x D45mm
SB001-S4

XS-SB001-S4

Specifications:
SB001-S8

XS-SB001-S8
R4 Solar Beam Sensors

XS-SB001-R4
SB001-R6 Solar Beam Sensors

XS-SB001-R6
  • Working voltage: 3.2V
  • Battery Type: LiFePO4li-ion battery
  • Battery capacity: transmitting terminal 600mA, receiving terminal 1800mA
  • Static working current: transmitting terminal≤0.6mA, receiving terminal≤0.6mA
  • Infrared light frequency: 38KHz
  • Infrared light wavelength: 940nm±20nm
  • Number of infrared beams: 2 - 8 beams
  • Wireless transmitting frequency: FM 433MHz
  • Sensor Infrared distance: 10 – 100metres
  • Wireless transmitting distance: 100 – 1000metres
  • Solar electric panel output current: ≥2mA at an illumination level of 1800Lx
  • Outdoor illumination intensity in rainy days is about: 2000LX
  • Working environment temperature range: -30℃¢«70℃
  • Maximum alarm times in 24 hours: ≤50 times

Package Includes:
  • 1 x Pair Wireless Solar Sensors
  • 4 x Solar Sensor Mounting brackets 
  • 1 x Instruction Manual
XS-SB001-R8_Solar Beam Sensors

XS-SB001-R8

Prices inclusive of GST

 

 

 

 

 

 
XS-2020C

Features:

XS-2020C

Please select Shipping Option HERE before checkout

$399

$349

Alarm Panel Receiver for Solar Sensors with built in Phone Dialer & CID Protocol
  • 1-100 independent wireless defense zones can be programmed and each defense location can be armed or disarmed independently.
  • Arm and Disarm using the Remote Controls or via the Alarm Panel
  • The wireless receiving host can pre-set two groups of on/off times, and can indicate present on/off state.
  • Select 3 kinds of alarm sound and four levels of alarm sound volume.
  • Ten pieces of up-to date alarm messages can display simultaneously.
  • 60 pieces of latest alarm messages can be inquired.
  • Easily connect Optional Backup battery, the Alarm Panel is equipped with floating charge device and will also alert of low battery power.
  • Automatically dial six telephone numbers and two groups of pre-set telephone numbers provided by ADEMCO CID Centre when alarming.
  • The pre-set telephone numbers can be dialed 3-9 times.
  • Will automatically cut off any calls to the same phone line in the event of the alarm triggering.
  • Has dial pause function and is compatible with built-in exchange system.
  • Can receive long distance phone calls.
  • Telephone line short circuit or cut-off report function can be opened/closed.
  • A NO/NC relay output and a +12V DC output are provided to connect other devices such as a wired siren, strobe light etc

Specifications:
  • Receiving Frequency: 433MHz
  • Wireless Receiving Sensitivity: ≤0.2μV (12db SINAD)
  • Operating Voltage: AC220V±15% 50Hzô¬DC 12V~13.8V
  • Operating Current: Standby Current ≤75mA, Alarm Current: ≤250mA
  • Operating Environment: -10℃~±50℃
  • Built in Siren: up to 110 dB

Package Includes:
  • 1 x Alarm Receiving Panel
  • 1 x Antenna
  • 2 x Remote Controls
  • 1 x Manual

 

 
Switch out Adapter

Package Includes:
  • 1 x Switch out Adapter
  • 1 x 433Mhz Antenna
  • 1 x Manual

XS-SA-8

Please select Shipping Option HERE before checkout

$299

$249

Switch out Adapter - Converts the Solar Sensors 433Mhz Wireless Signal into a Wired Signal
The 433MHz FM Signal Switch-out Adapter is used to convert the wireless signal transmitted by the Solar Powered Sensors and connects to almost any type of wired Alarm Panel.
 
Simple DIY Installation - Installation is available in Auckland if required - See HERE
 
Simply connect the + - power wires of the Switch out Adapter to the + - Aux connection on a wired Alarm Panel, connect zone wires from the Switch Out Adapter to resistors in the selected zone input on the wired Alarm Panel.
The Switch out Adapter can also connect to our 8800, 8900 or T1 Alarm Panels so if you are wanting to purchase an Alarm System and also wish to connect the Solar Sensors then this is not a problem.
 
The Switch out Adapter has 8 defense zones; each defense zone can connect at most 8 Solar-Powered sensors.
 
The size of this unit is approx the same as a Broadband Router and also very light.

 

 
[Home] [Home Alarms] [GSM Alarms] [GSM Light Alarm] [VandalProof Alarm] [GSM Camera] [Wireless CCTV] [Wireless Sensors] [Wireless Sirens] [Ordering] [Shipping] [Contact Us]

All pricing on this web site is in New Zealand dollars and is inclusive of 15% GST (tax). GST is charged to New Zealand customers only

Kiwi Buy Direct 2008 - 2012